Troubleshooting; Environmental Protection - eta Vital Blend MINI Instructions For Use Manual

GB
Some ingredients can colour the accessories in some way. But the change does not affect
the function of the appliance and it is not a reason for a claim. This colouring usually
disappears after some time. Never dry plastic moldings over a heat source (e. g. heater,
electric/gas stove). Store the appliance after cleaning at a dry, dustfree and safe place, out
of reach of children and incapacitated people.
Replacing the rubber feeder A6
The rubber feeder is inserted in the driver unit shaft and is not fixed there. To remove the
feeder, use a suitable tool, such as small screwdriver or narrow pliers, to take and pull the
feeder up (see Fig. 1).
VII. TROUBLESHOOTING
Problem
The appliance won't
start
The appliance stops
working
Knife is not rotating or
the appliance vibrates
too much
More extensive maintenance or maintenance requiring intervention in the inner parts
of the appliance must be carried out by professional service!
Failure to comply with the instructions of the manufacturer will lead to expiration
of the right to warranty repair!
If you are unable to fix the problem, or if you need any further information about the
appliance or service centres, please contact your distributor.
VIII. ENVIRONMENTAL PROTECTION
If the dimensions allow, there are labels of materials used for production of packing,
components and accessories as well as their recycling on all parts. The symbols specified
on the product or in the accompanying documentation mean that the used electric or
electronic products must not be disposed of together with municipal waste. For proper
disposal of the product, hand it over at special collection places where it will be taken
over free of charge. Suitable disposal of the product can help to maintain valuable natural
resources and to prevent possible negative impacts on the environment and human health,
which could be the possible consequences of improper waste disposal.
Cause
Power supply not connected
The mixing bowl are not
mounted properly.
The ingredients being
processed are too heavy or
the container is too full
The rubber feeder on the
driver unit shaft is worn
32
Check the power cord, the plug
and the socket
Check and fasten to mixing
bowl the right position in order
to unlock the safety lock
Switch off the appliance,
let it cool down, divide the
processed food into smaller
portions and process them
gradually
Replace the rubber feeder
with a new one of the same
type using a suitable tool (see
MAINTENANCE section).
/ 53
Solution