Features Of The Device (Pic. 1); Preparation For Use - eta Vital Blend MINI Instructions For Use Manual

II. FEATURES OF THE DEVICE (PIC. 1)
A – propulsion unit
A1 – main switch
A2 – PULSE button for maximum revolutions
A3 – speed control dial
A4 – propulsion shaft
A5 – locking mandrel for attaching the container
A6 – rubber feeder
B – jar
C – lid
C1 – plug
D – pusher
III. PREPARATION FOR USE
Remove all packaging material, remove the accessory. Remove all adhesive foils, stickers
or paper from the appliance. Wash all parts which will come in touch with food in hot water
with soap, rinse them thoroughly with clean water and wipe dry or let dry before first use.
Put the blender with the selected accessories on a flat, stable, smooth and clean work
surface at the height of at least 85 cm, out of reach of children and incapacitated people.
Make sure that the power cord is not damaged and that it does not lead through any sharp
or hot surfaces. Plug power supply fork to the electric power. Choose the amount of the
processed food so that the maximum volume of the containers marked with the gauge line
is not exceeded. Possible short-time mild smoke when the appliance is operated for the
first time is not a defect and the appliance is not subject to a complaint for this reason.
main switch (A1)
position (0) – standby mode of the blender
position (I) – switching the blender on (regulated speed)
PULSE button for maximum revolutions (A2)
This is an instantaneous switch (the motor is working at max. capacity and is in operation
till the switch is switched over). Switch the PULSE button for maximum revolutions A2 in
the lower position (I) and keep it in this position throughout the pulse duration.
Speed control dial (A3)
The speed control dial can only be used if the switch is set in position (I) (regulated speed).
By rotating the speed control dial with signal lights indicating operation A3 clockwise, you
can smoothly set the rate of speed within the MIN and MAX range.
The appliance will be put in standby mode only if the container B is attached properly,
ATTENTION
releasing the safety lock.
27 / 53
GB