Table of Contents
Advertisement
Assigning home station to VideoTerminal
You can implement the so-called internal call function with the optional call button
for home stations. A voice connection between the home station and the VideoTer-
minal can be established via the internal call.
To assign a home station call button to the VideoTerminal, proceed as follows:
3 s
26
1. Press the "System prog." button on the control device
for 3 sec. to start programming mode.
2. Press the call button on the home station for 3 sec-
onds. Release the call button following the brief
acknowledgement tone sounds.
✓ The home station outputs a long acknowledgement
tone.
i
Releasing the button after 3 seconds
If the button is not released after the first acknowledge-
ment tone, all call buttons of the home station will be
deleted after an additional 3 seconds.
3. Press the
button on the VideoTerminal for 3 sec-
onds until a brief acknowledgement tone is heard.
✓ A long acknowledgement tone indicates successful
assignment.
Three short acknowledgement tones indicate faulty
assignment. The memory of the VideoTerminal may
already be occupied. A maximum of ten call buttons can
be assigned.
4. Briefly press the "System progr." button on the control
device to exit the programming mode.
Advertisement
Table of Contents
