Table of Contents
Advertisement
Brightness - contrast - colour
i
Selecting camera beforehand
The colour camera must be selected before one of the menu items "Brightness",
"Contrast" or "Colour" is marked. If no camera has been selected, the message "No
camera selected" appears.
B r i g h t n e s s
b a c k
i
Settings with several VideoTerminals and colour cameras
These settings only apply to the connection from the active VideoTerminal to the
active colour camera in each case. This means that if several VideoTerminals and/
or colour cameras are installed, these parameters can be set individually for each
camera on each VideoTerminal.
Switch-on time
S w i t c h - o n t i m e
b a c k
C a m e r a 1
5 0 %
6 5 s
In the "Brightness", "Contrast" or "Colour"
menu, the respective parameters can be
selected and set by turning and pressing
the operating button.
Pressing the operating button saves the set
value and exits the menu.
If the menu is exited with the Menu button
(back), the change is not saved.
Factory setting: 30 seconds
The switch-on time specifies after what
time the VideoTerminal is automatically
switched off after being switched on man-
ually.
With the operating button you select the
switch-on time of the VideoTerminal in the
range of 20 to 120 seconds.
Pressing the operating button saves the set
value and exits the menu.
If the menu is exited with the Menu button
(back), the change is not saved.
17
Advertisement
Table of Contents
