Table of Contents
Advertisement
Factory setting
F a c t o r y s e t t i n g
D i s p l a y p a r a m e t e r s
D e l e t e c a m e r a s
D e l e t e c a l l a s s i g n m e n t
D e l i v e r e d s t a t e
b a c k
A differentiation is made between:
Display parameters: Here the values of the menu items Priority, Resistor, Display,
Language, Brightness, Contrast, Colour and Switch-on time are reset to the factory
setting.
The assignments to colour cameras, call buttons and stations are retained.
Delete cameras: All camera assignments are cleared here. The values in the menus
Frequency, Lighting, Brightness, Contrast and Colour are reset to the factory set-
ting.
"Delete cameras" is, for example, required if the bus connector of the video door
station is to be replaced.
Once you have executed this function, the cameras must be registered again: For
this purpose, start the programming mode on the control device and press any call
button on all door stations with a colour camera for 3 seconds each. Important: Go
through the door stations in the order which is to be displayed later in the video
image (e.g. Main door camera 1, Side door camera 2 etc.).
Delete call assignment: Here all assigned call buttons and the ringing tone melo-
dies are deleted or reset.
Delivered state: Here all menu items of the VideoTerminal are reset to the factory
setting. In addition, the assignments to call buttons and colour cameras are deleted.
Here the settings of the VideoTerminals are
reset to the factory settings.
23
Advertisement
Table of Contents
