Assigning Home Station Via Floor-Call Button - Gira 1288 00 Operating Instructions Manual

Assigning home station via floor-call button

If you cannot access the home during start-up, you can also
assign the home station via a connected floor-call button:
1. Press the "System prog." button on the control device for
3 seconds to start programming mode (see Page 19).
2. Press the call button of the home station to be assigned at
the door station for 3 seconds until you hear a short
acknowledgement tone.
3 You will hear a long acknowledgement tone.
3. Go to the floor-call button of the home station to be
assigned.
Press the floor-call button for 3 seconds until you hear a
short acknowledgement tone.
3 A long acknowledgement tone indicates successful
assignment.
Only possible
with directly connected home station
With several parallel home stations, only the home station
connected directly to the floor-call button can be taught in via
the floor call button.
4. Press the "Systemprogr." button on the control device to
exit the programming mode.
27