Assigning Door Station To Videoterminal; Assigning Videoterminal Via Floor-Call Button - Gira 2600 Series Installation And Operating Instructions Manual

Assigning door station to VideoTerminal

To assign a door station call button to the VideoTerminal, proceed as follows:
3 s

Assigning VideoTerminal via floor-call button

If you cannot access the home during commissioning, you can also assign the
VideoTerminal via a connected floor-call button:
In this case the VideoTerminal behaves like a home station of the Gira door commu-
nication system. The assignment with a floor call button is described in the system
manual.
1. Press the "System prog." button on the control device
for 3 sec. to start programming mode.
2. Press the call button on the door station for 3 seconds.
Release the call button following the brief acknowl-
edgement tone sounds.
✓ The door station outputs a long acknowledgement tone.
i
Releasing the button after 3 seconds
If the button is not released after the first acknowledge-
ment tone, all call buttons of the door station will be
deleted after an additional 3 seconds.
3. Press the button on the VideoTerminal for 3 sec-
onds until a brief acknowledgement tone is heard.
✓ A long acknowledgement tone indicates successful
assignment.
Three short acknowledgement tones indicate faulty
assignment. The memory of the VideoTerminal may
already be occupied. A maximum of ten call buttons
can be assigned.
4. Briefly press the "System progr." button on the control
device to exit the programming mode.
25