Step 3: Break-In The New Clutch - Rekluse RadiusCX Installation & User Manual

For ktm/husqvarna ds clutches
Hide thumbs Also See for RadiusCX:
Table of Contents

Advertisement

Step 3: Break-in the new clutch

Once you install your new clutch, it is important to break it in.
A series of roll-on starts are used to break in the clutch.
Follow these procedures for breaking in your clutch and any
time new friction disks, EXP bases, Teflon pads, or wedges
are installed.
Failure to follow the break-in procedure and oil screen
inspection process could cause motor oil delivery
failure which can result in motor failure, serious injury,
or death.
Break-in Procedure
Rev Cycles:
1. Place the bike in NEUTRAL.
2. With your hand off the clutch lever,
rev the engine 10 times, being sure
to let it return to idle between
each rev cycle.
3. With the engine still running, pull in
the clutch lever, then click the bike
st
into 1
gear. Slowly release the
clutch lever. The bike should stay
in place or have a slight amount of
forward creep.
Doc ID: 191-7913A
Doc Rev: 082018
Number of times
10 rev cycles
Pg. 35

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RadiusCX and is the answer not in the manual?

Table of Contents