Step 2: Replace Oe Slave Cylinder - Rekluse RadiusCX Installation & User Manual

Step 2: Replace OE slave cylinder

In this step, the OE slave cylinder is replaced with the
Rekluse slave cylinder. Work quickly when performing the
following steps. This method retains the fluid inside the line,
and makes the final bleeding step easier.
1. Stand the bike up and lean it on its kickstand, or place it
on a suitable bike stand.
2. On the left side of the
bike, while leaving the
OE slave cylinder
intact on the engine,
use a wrench to
remove the banjo
bleeder bolt from the
OE Slave cylinder.
Pg. 22
Doc ID: 191-7913A
Doc Rev: 082018