Turning The Terastation On And Off - Buffalo TeraStation 3010 User Manual

Chapter 1 Getting Started
10
Status LEDs
Normally, these LEDs blink green when drives are accessed. If a drive fails, its LED will turn red.
11
Fan
Spins to prevent overheating inside. Do not block the fan.
12
USB Port
Compatible Buffalo USB drives, USB memory devices, and USB UPS device connections can be connected. USB
hubs are not compatible.
13
LAN Port 1 (1GbE)
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 1000
Mbps.
14
LAN Port 2 (2.5GbE)
Connect an Ethernet cable to use this port for your network. It is available for communicating at max. 2.5 Gbps
if using the included Ethernet or category 6A cable.
Note: To communicate at up to 2.5 Gbps, all network devices must be compatible with 2.5GbE.
15
Power Connector
Use the included power cable to connect to a UPS, surge protector, or outlet.
16
Anti-Theft Security Slot
Use this slot to secure your TeraStation with a cable lock (not included).
17
Serial Number
This sticker shows the TeraStation's serial number.
18
UID Button
Press this button to cycle the blue LED on and off.
19
Link/Act LED
Glows green when the TeraStation is connected to a network and blinks when the connection is experiencing
activity.
20
Link/Act LED
Glows amber when the TeraStation is connected to a network at 100 Mbps or 2.5 Gbps and blinks when the
connection is experiencing activity.
21
Link/Act LED
Glows green when the TeraStation is connected to a network at 1000 Mbps and blinks when the connection is
experiencing activity.

Turning the TeraStation On and Off

Note: Do not disconnect or reconnect the internal drives while turning on or off the TeraStation.
Press the power button on the TeraStation to turn it on.
To turn off the TeraStation, press and hold down the power button for three seconds. Don't unplug the power cable
without powering the TeraStation off first.
You can also shut down or restart the TeraStation remotely from Settings using the procedure below.
1
Double-click the NAS Navigator2 icon ( ) to start NAS Navigator2.
16