Reconfiguring After Failover Occurs - Buffalo TeraStation 3010 User Manual

Chapter 5 Backup
Note: If the main TeraStation fails but all LAN port connections on the backup TeraStation remain up, you cannot
replace the main TeraStation with the backup TeraStation from Settings. In such a case, use the function button
instead.

Reconfiguring After Failover Occurs

When the backup TeraStation replaces the main TeraStation, the
configure failover again, follow the procedure below using a new TeraStation unit. The following procedure is an
example using the replaced backup TeraStation ("main TeraStation") and the new TeraStation ("backup TeraStation").
If you don't want to configure failover with the new TeraStation, cancel the failover settings by following steps 1–5
below and restart both TeraStations. The
Note: The following procedure will also work if failover occurs unexpectedly.
1
After failover occurs, log in to Settings for the new main TeraStation.
If you have configured to synchronize with the UPS device connected to the failed TeraStation, the
will be displayed on the main TeraStation. In such a case, follow the procedure below to change the UPS
settings on the new main TeraStation. If you hadn't, skip to the next step.
a. Disconnect the UPS cable from the failed TeraStation and connect it to the main TeraStation.
b. Click Management.
c. Click the settings icon (
d. Click Edit.
e. Select "Sync with UPS connected to this TeraStation" and reconfigure the desired UPS settings.
f. Click OK when completed.
2
Click Backup.
3
Click the settings icon (
I49
message will disappear.
) to the right of "Power Management".
) to the right of "Failover".
104
I49
message may appear on NAS Navigator2. To
E10
error