Buffalo TeraStation 3010 User Manual page 16

Chapter 1 Getting Started
TS3420RN
10
11 18
1
Power Button
To power on the TeraStation, connect the power cable and wait for 10 seconds, then press the power button.
To power off the TeraStation, press and hold down the power button for three seconds.
If the TeraStation beeps, pressing and holding this button for a short period will stop the beeping.
2
Power LED
On the TS3220DN and TS3420DN TeraStation models, the LED glows green when the TeraStation is on. On the
TS3420RN TeraStation model, the LED glows white when the TeraStation is on.
3
Info LED
If there is a status message, the info LED will light up amber. Check the Settings interface or NAS Navigator2 to
see the status message.
4
Error LED
If there is an error, the error LED will light up red. Check the Settings interface or NAS Navigator2 to see the
error message.
5
LAN1 LED
When LAN port 1 is connected, this LED glows green and blinks when the connection is experiencing activity.
6
LAN2 LED
When LAN port 2 is connected, this LED glows green and blinks when the connection is experiencing activity.
7
Function Button
Use this button for dismounting USB devices, rebuilding RAID arrays, configuring failover, stopping the
TeraStation's beeping, and initializing settings using a USB drive.
8
Drive Lock
Open the front panel with the key to replace drives or access the init button.
9
Init Button
Press and hold down this button with something pointed to initialize the TeraStation's admin username and
password, IP settings, SSL, and service port restriction settings to their factory default values. The effects of this
button can be changed in Settings.
17 10 18 3 4 5 6
20
19
12 13 14
2 10 1 7 10 9
21
16
15
12
15 11