Buffalo TeraStation 3010 User Manual page 226

Chapter 10 Appendix
Code
I33
I34
I37
I38
I40
I41
I42
I43
I44
I45
I46
I47
I48
I49
I50
I51
I52
I54
I55
Description
An error occurred in replication, or
synchronization between the main
TeraStation and the backup TeraStation
failed during failover configuration.
A virus scan found a virus.
The initialization process has been started
by using the USB initialization drive and
settings are being initialized.
Settings initialization is completed.
Beginning settings initialization. All data
on the drive in slot 1 will be deleted.
Press the function button to start the
settings initialization process.
Preparing to start the settings initialization
process.
The TeraStation was started from the USB
initialization drive, but the settings cannot
be initialized from this USB initialization
drive.
Initialization from the USB initialization
drive was initiated, but the drive in slot 1
was not detected.
Initialization failed.
Data migration or conversion (RAID
migration) is in progress.
Data migration or conversion (RAID
migration) is in progress.
This TeraStation is ready to become
the failover backup device for the main
TeraStation.
The main TeraStation in the failover
configuration cannot be found.
Failover maintenance is in progress.
Initializing the failover configuration.
A new firmware version has been released.
The backup job failed.
Authentication during initialization of
settings failed.
Corrective Action
From Settings, navigate to Backup >
Replication and click Resync to execute
resynchronization.
If you configured the subfolders' access
restrictions to be inherited to the
replication or failover destinations, disable
them or change the destinations.
Delete the infected files from the
quarantine folder.
-
-
-
-
-
-
Make sure that the drive in slot 1 is present
and fully inserted into its slot.
-
Do not turn off the TeraStation's power.
Do not turn off the TeraStation's power.
Press and hold down the function button
of the failover backup TeraStation until it
stops beeping to accept failover backup
status.
Make sure that the main TeraStation is on,
working, and connected to the network.
Do not turn off the TeraStation's power.
Do not turn off the TeraStation's power.
Update the firmware by referring to the
"Updating the Firmware"
7.
Refer to the
Fails" section in chapter 5 and try the
respective corrective actions.
Settings can only be restored for the
TeraStation whose settings were originally
saved.
225
section in chapter
"Backup Logs for If Backup