Advertisement
Jumpers Must Be on Terminal Pins: Do not remove and discard jumpers. The absence
of a jumper does not qualify as the OFF position. If whole units are desired, J3 and J4
must both have a jumper in the OFF position.
J3 and J4 cannot both be in the ON position: If this is the case, two decimal points will
appear on the display. This is not a valid jumper configuration.
3. Replace the rear panel of the display. See
Secure Cable and Tighten Cover Upon Reassembly
LectroCount XL LED Remote Displays are assembled and shipped ready for final cable
termination. If the pre-installed shielded cable is removed during installation, be sure to
secure the cable and tighten the cover so the vapor seal is maintained. See
Specifications
.
28
Get the latest PDF manual:
Mobile/online version of this manual:
https://www.lcmeter.com/resources/technical/manuals
https://www.lcmeter.com/manuals
Torque Specifications
XL LED Remote Display
.
28
Torque
27
Advertisement
