Advertisement
Wiring
This chapter provides instructions on the wiring for:
·
Model E1615
·
Model E1616
·
Model E1617
·
Model E1618
·
Automatic display shutoff
·
Dual display kit
·
Rate of flow switch kit
·
Reset switch kit
Shielded cable for each display type - All display models
All four display models ship with a 30-foot 4-wire shielded cable with 22-gauge wire. If
alternate cabling is necessary, Liquid Controls recommends a similar 4-wire shielded cable
with 22 gauge wire or larger and a maximum cable length of 30 feet.
Connect the J1 Jumper - All display models
All four display models ship with a jumper, which must be installed between terminal 52 and
terminal 53 on the J1 terminal block of the display. During rewiring, take time to ensure that
this jumper is in place.
Wiring for Model E1615
Model E1615 of the LectroCount XL LED Remote Display is designed for use with a
LectroCount LCR-II or LCR 600. LectroCount LCR-II or LCR 600 electronic registers contain a
840404, 84040, or 81920 CPU board.
If the power to the LectroCount LCR-II or LCR 600 exceeds 24 VDC, then the remote
display should be powered from Pin 32 on J8, 5 VDC.
Get the latest PDF manual:
Mobile/online version of this manual:
24 VDC Power
https://www.lcmeter.com/resources/technical/manuals
https://www.lcmeter.com/manuals
XL LED Remote Display
13
Advertisement
