Advertisement
Wiring for Model E1616
Model E1616 of the LectroCount XL LED Remote Display is designed for use with a
LectroCount LCR (CPU board 81547-2) or a LC3 CPU board (Terminal Board 81924).
If the power to the LectroCount LCR-II or LCR 600 exceeds 24 VDC, then the remote
display should be powered from Pin 32 on J8, 5 VDC.
Refer to the figure below and follow these steps to wire the LectroCount XL LED Remote
Display model E1616 to a 81547-2 or LC3 CPU board:
1. Open the LectroCount register. Refer to the specific LectroCount Register manual for
specific instructions regarding opening, closing, and sealing the electronic register.
2. Attach a cable gland and/or conduit connector to a port on the LectroCount electronic
register.
3. Route the shielded cable through the cable gland and into the LectroCount register
housing.
4. Connect the four wires of the shielded cable to these terminals on the LectroCount CPU
board:
LectroCount LCR – On the J12 terminal block (81547-2), connect:
• XL LED terminal 53 (red wire) to LCR terminal 45
• XL LED terminal 54 (white wire) to LCR terminal 39
• XL LED terminal 55 (green wire) to LCR terminal 40
• XL LED terminal 56 (black wire) to LCR terminal 41
LectroCount LCR – On the J1 terminal block (81924) connect:
• XL LED terminal 53 (red wire) to LC3 terminal 1
• XL LED terminal 54 (white wire) to LC3 terminal 5
• XL LED terminal 55 (green wire) to LC3 terminal 6
• XL LED terminal 56 (black wire) to LC3 terminal
Get the latest PDF manual:
Mobile/online version of this manual:
24 VDC Power
https://www.lcmeter.com/resources/technical/manuals
https://www.lcmeter.com/manuals
XL LED Remote Display
15
Advertisement
