Advertisement
Specifications for Single Channel Pulsers
Single Channel Pulse Device
Signal Level
Output
Frequency
Wiring for the Automatic Shutoff
The LectroCount XL LED Remote Display can be wired to turn on and shut off automatically. If
wired for automatic shutoff, the display will automatically turn on when a delivery is initiated.
The display will remain lit until a delivery ticket is printed. When the delivery ticket begins
printing, the display will automatically shut off. Only models E1615 and E1616 can be wired for
automatic shutoff.
Refer to the figure below and follow these steps to wire the LectroCount XL LED Remote
Display for automatic shutoff:
1. Connect the power and two signal wires.
2. Instead of connecting the black (GND) wire to terminal 41 on the J12 terminal block,
connect the black (GND) wire to terminal 44 of the J12 terminal block on the LectroCount
register CPU board.
Get the latest PDF manual:
Mobile/online version of this manual:
https://www.lcmeter.com/resources/technical/manuals
https://www.lcmeter.com/manuals
·
Solid State
·
·
·
1.5 mA sinking
·
5 kHz maximum
XL LED Remote Display
20
Advertisement
