Advertisement
Wiring for the Rate of Flow Switch Kit
The dual display kit allows two LectroCount XL LED Remote Displays to display the delivery
volume of a single LectroCount electronic register.
The Rate of Flow Switch Kit is compatible with LectroCount LCR-II and LCR 600 electronic
registers only.
The Rate of Flow Switch Kit is an optional accessory that toggles the LectroCount XL LED
Remote Display from the delivery volume to the current flow rate. To toggle to the current flow
rate display, push the button. After five seconds, the display will return to the delivery volume.
The select switch kit includes:
·
Push button (w/ cord grip)
·
Cord grip (2)
·
4-port conduit box
·
30-foot, 2-wire, shielded cable
The switch kit accessory connects directly to a LectroCount LCR-II or LCR 600.
To function with an LCR 600, the Rate of Flow Switch Kit must be wired to a 840404 CPU
board flashed with version 2.12 or higher of the SR600 firmware.
Follow these steps to install the Rate of Flow Switch Kit:
1. Determine the best location for the push button.
2. Mount the conduit box at the determined location.
3. Screw a cord grip into the conduit box and a port in the LectroCount register.
4. Route the 30-foot shielded cable through the cord grips in the conduit box and the
LectroCount register and tighten the cord grips.
Get the latest PDF manual:
Mobile/online version of this manual:
For Model E1615 Only
LCR 600 Software Requirements
https://www.lcmeter.com/resources/technical/manuals
https://www.lcmeter.com/manuals
XL LED Remote Display
23
Advertisement
