Input - Datavideo HS-3200 Instruction Manual

Input

In this option, you will be allowed to set the mode of display in the respective Input
windows of the Multiview display. First select the input that you would like to configure and
then for each selected input, set the mode of input by selecting one of the modes listed as
follows:
 Still – Displays the still picture loaded into Inputs 1-12 in the respective input window.
 Freeze – Freezes the current video played in the Input window.
 Live – Live view or video display in the Input window.
TC-200 Mode: The TC-200 is a character generator built into the switcher to allow keying of
CG text or graphics over the live video. Built-in TC-200s are available on Inputs 9-12 only.
Follow the steps below to set up your CG text or graphics after TC-200 mode is enabled on
the selected input (Inputs 9-12).
1. Connect the laptop to one of the HDMI ports of the HS-3200 switcher using an HDMI
cable. In this example, we will be using HDMI port 9 for illustration purpose.
2. Open CG-250 on the laptop and create a CG image that can then be sent to the HS-3200
via the built-in TC-200.
3. Switch ON the HS-3200's power button and after the boot up is complete, the Multiview
should be displayed on the connected monitor.
4. On the Multiview, Input 9 window should display the CG image.
5. Press the "MENU" button on the HS-3200's control panel to open the OSD menu on the
Multiview display and then select the "Inputs" sub menu.
6. Select "Input 9" from the Input option and enable TC-200 mode by turning on TC-200
Md.
Inputs
Proc Amp
Crosspoint
Audio XPT
7. Move to the "Keyer" sub menu.
8. Select "DSK 1 or 2" from the Keyer option and set Key and Fill Sources to Input 9.
Keyer Keyer
Keyer Ctrl
Key Source
Input Input 9
Black
Audio Gain
Input 9
Off
DSK1
Linear
Lift
Input 9
Mode
0% White
0 dB Delay
Split
0% Gain 1.0 Invert
Fill Input 9
56
Still TC-200 Md
100% Chrom
0 ms
Opac 100%
On
1.0
Off