Keyer - Datavideo HS-3200 Instruction Manual

 Input 10: Image source loaded to input button 10
 Input 11: Image source loaded to input button 11
 Input 12: Image source loaded to input button 12
 Still 1: Still picture loaded to Still 1 button
 Still 2: Still picture loaded to Still 2 button
 Flex Src: Flex button source
 Matte: A configurable color screen and the Matte value can be set in Matte option
of the Start menu
 Bars: Color Bars

Keyer

The Keyer on the Flex Src sub menu is basically the DSK settings. Assign Key source to the
first field and Fill source to the second field. Once the keyer is enabled, the CG or DSK image
will be shown on the FLEX Scr screen.
The steps outlined below will guide you through the entire configuration process.
System Hardware Setup
1. Connect the laptop to the PC IN HDMI port of the TC-200 Title Creator using an HDMI
cable.
2. Open CG-250 on the laptop and create a CG image that can then be sent to the HS-3200
via TC-200.
3. At the rear of the HS-3200, the two SDI output ports of the TC-200, Key Source and Fill
Source, are respectively connected to the HS-3200's SDI 1 and SDI 2 inputs.
4. Switch ON the HS-3200's power button and after the boot up is complete, the Multiview
should be displayed on the connected monitor.
Menu Settings
5. On the Multiview, Input 1 window displays the Key Source, Input 2 window displays the
Fill Source.
6. Press the "MENU" button on the HS-3200's control panel to open the OSD menu on the
Multiview display and then select the "Flex Src" sub menu.
7. CG Overlay input setting (Input 1 / Input 2): In the Keyer option, set the first field to
Input 1 (Key) and the second field to Input 2 (Fill).
Flex Src Flex Src Bgnd
P-in-P 1 Src
P-in-P 2 Src
P-in-P 3 Src
P-in-P 4 Src
Black
Black
Black
Black
Black
Keyer Input 1
Enable
Enable
Enable
Enable
Input 2
53
On
On
On
On
Enable On