Rear Panel Overview - Datavideo HS-3200 Instruction Manual

1.2 Rear Panel Overview

AUDIO OUT
Supports two channels of the XLR
Balanced Audio output.
AUDIO IN
Supports four channels of the XLR
Balanced Audio Input.
See Section 4.8 Audio for audio setup.
HDMI Video Inputs 9 – 12
HDMI Video Inputs 9-12
The HDMI inputs are
labelled 9~12.
Stream Port
The Stream Port allows the user to
stream the program or video to
any IP network via the built-in
NVS-31 video streaming server.
Connect the laptop to this port to
directly access the NVS-31 for
configuration.
Note: See Chapter 7 for details.
SDI Video Inputs 1 – 8
SYNC I/O
The lower row of
The HS-3200 can be
SD/HD-SDI inputs are
synchronized with other studio
labelled 1~4. The upper
equipment such as cameras.
row of SD/HD SDI inputs
REF IN accepts Tri-level or
are labelled 5~8.
Black Burst sync. REF LOOP can
be used to pass the sync signal
to other studio equipment such
as cameras or recorders.
See the section on Genlock for
details.
GPI OUT
The GPI socket can be used for
HDMI OUT 1/2/3
simple external control.
The three HDMI outputs can only
display the Program View.
See Appendix 2 for more details.
SDI/HDMI Video Outputs
The SDI/HDMI video outputs
are user-defined outputs. Each
of these outputs has the
option to be:
 Multiview
 Program
 Preview
 Program + DSK
 Clean Program
 Clean Preview
 Input 1 – 12
14
TALLY OUT
The SE-3200 Tally Output port provides bi-
colour tally information to a number of
other Datavideo products, such as the ITC-
100 eight channel talkback system or the
Datavideo TLM range of monitors.
See Appendix 1 and Tally Mode
details.
The power button starts
and shuts down the
machine power.
DC IN
Connect the supplied 12 V
PSU to this 4 PIN XLR
socket
Pin 1 = GND ( - )
Pin 2 = NC
Pin 3 = NC
Pin 4 = VCC ( + )
USB FW Upgrade Port
Connect the USB drive
containing the switcher's
Ethernet Port
latest firmware files to this
Used to connect the
port and start the
switcher to the PC or
firmware upgrade process
laptop so that the unit can
on the OSD MENU.
be controlled remotely via
PC software (Chapter 3).
Note: See Firmware
Update section for details.
for more