Global Setup - Roland TM-6 PRO Data List

GLOBAL SETUP

Parameter
BASIC tab
MIDI Tx/Rx Sw
MIDI Channel
Program Change Tx
Program Change Rx
Soft Thru USB MIDI In
Local Control
Device ID
Transmit Edit Data
Receive Exclusive
CTRL tab
HH Pedal CC
HH Note# Border
Cymbal Choke Shot
Sync Mode
Sync Out
PRGCHG tab
MIDI Program Change
Using the Local Control setting
If you're using a DAW with the performance data from the drum triggers and TM-6 PRO's sound generator
section, you should turn the Local Control "OFF. " Here's why.
We need to connect these sections in the following order: the performance data from the drum triggers 0
a DAW 0 the TM-6 PRO's sound generator section.
Since the performance data from the drum triggers and TM-6 PRO's sound generator section are connected
internally, such a connection order would normally be impossible. However, if the Local Control is "OFF, " the
performance data from the drum triggers and TM-6 PRO's sound generator section will be independent,
allowing you to use a DAW as shown here in the illustration.
Specifying the HH Note# Border
The note number transmitted when you strike the hi-hat will change depending on the amount of pressure on the hi-hat pedal.
At the factory default value (90), the closed hi-hat note number will be transmitted only if the hi-hat drum trigger is played with the pedal completely depressed. If you want this
note number to be transmitted when the pedal is slightly raised, set this to a value such as "90. "
* In some cases, changing the hi-hat note number border setting might cause a song to play back differently than when it was recorded.
Value
OFF, ON
1–16Ch
OFF, ON
OFF, ON
OFF, ON
OFF, ON
17–32
OFF, ON
OFF, ON
OFF, 1, 2, 4, 11, 16, 17, 18, 19
0–127
OFF, ON
Specifies the synchronization signal according to which the TM-6 PRO operates.
INTERNAL
EXTERNAL
OFF, ON
1–127
Explanation
Turns the transmitting and receiving MIDI messages on/off.
Transmit and receive channel.
Turns program change transmission on/off
Turns program change reception on/off
Specifies whether performance data received from the TM-6 PRO's USB COMPUTER port is
transmitted to the MIDI OUT connector (ON) or are not transmitted (OFF).
Turns on/off the connection between the performance data from the drum triggers and the
TM-6 PRO's sound generator section
Normally you'll leave this "ON. " If this is "OFF, " the performance data from the drum triggers is not
connected to the TM-6 PRO's sound generator section.
Device ID setting
The setting described here is necessary only when you wish to transmit separate data to two or
more TM-6 PRO units at the same time. Do not change this setting in any other case.
Specifies whether changes in the TM-6 PRO's settings are transmitted as system exclusive messages
(ON) or not transmitted (OFF).
Specifies whether system exclusive messages are received (ON) or not received (OFF).
Control change used for transmitting/receiving the depth to which the hi-hat pedal pressed
This number specifies the pedal position at which to switch from open hi-hat to closed hi-hat.
* There's no need to change this setting if you're performed and recording only with the TM-6 PRO
and the drum triggers.
Switches support for the performance technique of striking a pad while choking it.
If this is "ON, " striking a pad while choking it immediately mutes the sound after it begins. If this is
"OFF, " the sound is not muted immediately even if you strike a pad while choking it.
Choose this setting if you're using the TM-6 PRO by itself without synchronizing it to another
device, or if you want another device to operate in synchronization with the TM-6 PRO.
The TM-6 PRO operates as a slave device. Choose this setting if you want the TM-6 PRO to operate
according to synchronization messages that it receives from another device.
Specifies whether MIDI synchronization messages are transmitted to another device (ON) or not
transmitted (OFF).
You can freely specify the correspondence between kits and the program change numbers that are
transmitted and received.
Drum trigger
DAW
TM-6 PRO
Sound generator
section
Local Control: OFF
MENU
15