Master Eq - Roland TM-6 PRO Data List

MENU
Meters shown in the MASTER COMP screen
In the MASTER COMP screen, the "input meter, " the "output meter, " and the "gain reduction meter" are displayed.
When Split Freq is "SINGLE" (single compressor)
Input meter
The "input meter" shows
the level (dB) being
input to the master
comp.
Output meter
The "output meter" shows the output level
following the master comp.

MASTER EQ

This is a four-band equalizer that is provided for each kit.
You can adjust the equalizer's effect (shelving and peaking) for the low frequency (LOW) and high frequency (HIGH).
The sound processed by the master EQ is output from the MASTER OUT jacks and the PHONES jack.
Parameter
[F3] button
TYPE (LOW and HIGH only)
Q
FREQ
GAIN
* If the Master Direct Sw is set to "DIRECT" in OUTPUT SETUP (p. 17), the master EQ effect is not applied to the sound that is output from the MASTER OUT jacks.
12
Gain reduction meter
The "gain reduction
meter" shows the change
in level (dB) produced by
the master comp.
Value
OFF, EQ ON
SHELV (Shelving),
PEAK (MID1 and MID2: fixed to
"PEAK")
0.5–8.0 (only when Type is set to
"PEAK")
20Hz– 1kHz (LOW)
20Hz–16kHz (MID1, 2)
1kHz–16kHz (HIGH)
-12–+12dB
When Split Freq is "10–16000Hz" (2-band compressor)
Gain reduction meter
The "gain reduction meter" shows
the change in level (dB) produced
by the master comp.
This is shown individually for the
low and high bands.
Explanation
Turns master EQ on/off.
Type of equalizer
Width of the frequency range
A higher Q narrows the affected area.
Center frequency
Amount of boost/cut
Input meter
The "input meter" shows the level
(dB) being input to the master comp.
This is shown individually for the low
and high bands.
Output meter
The "output meter" shows
the output level following
the master comp.