Display Settings; Technisat Connect Pin; Deleting Network Profile - TechniSat DIGITRADIO 370 CD IR Manual

> Now select whether to allow automatic retrieval of the IP address, gateway
etc. from your router (DHCP active) or if you would like to enter this manually
(DHCP inactive).
Please take into account that automatic retrieval of the IP address, gateway,
subnet mask only works if the DHCP function is activated in your router.
> One by one, enter the IP address, subnet mask, gateway address, primary
DNS and secondary DNS if required, using the Arrow buttons on the remote
control. Confirm each set value with the ENTER button.
> Now enter the name (SSID) of your WLAN network using the virtual keyboard
and confirm with OK.
> Select whether your WLAN network is Unencrypted, encrypted by WEP or by
WPA/WPA2 and confirm the following item.
> Then use the virtual keyboard to enter your WLAN password and confirm with
OK to start the connection process.
In general, the WLAN connection can be used after a few seconds.

16.3.2 Display settings

> Select [Display settings] to display the current network settings.

16.3.3 TechniSat Connect PIN

You can control the DIGITRADIO 370/371 CD IR via the TechniSat CONNECT App. To
do so, the PIN for the DIGITRADIO 370/371 CD IR must be entered in the App. You
can change the PIN as follows.
> Under [NetRemote PIN], enter a 4-digit PIN and select OK to save.

16.3.4 Deleting network profile

Use the [Delete All Inactive Networks] or [Delete All Network Connections] menu
items to delete all existing connections to a wireless network or to all configured
networks and to clear the settings you have made. If you wish to connect the device
to these networks again, you must carry out all the settings again.
80