Using Headphones; Cleaning - TechniSat DIGITRADIO 360 CD Instruction Manual

11.8 Using headphones

Do not listen to music at a high volume when using headphones. Doing so can cause permanent
hearing impairment. Turn down the radio volume to the lowest volume before using headphones.
When you connect headphones (not included in the scope of delivery), the speakers are muted and
sound is only heard via the headphones.
> Only use headphones with a 3.5 mm jack plug.
> Insert the headphone connector into the headphone socket (14) on the device.
> If you would like to listen via the speakers again, remove the headphone connection from the
headphone socket on the device.

12 Cleaning

To prevent the risk of an electric shock, you may not clean the device using a wet cloth or under
running water. Remove the mains plug prior to cleaning!
You may not use scouring pads, scouring powder and solvents such as alcohol, petrol, spirits, thinners,
etc.; they could damage the surface of the device.
Do not use any of the following substances: salt water, insecticides, chlorine or acid-based solvents
(ammonium chloride).
Clean the housing using a soft, moist cloth.
Only clean the display with a soft, cotton cloth. If required, use the cotton cloth with a reduced volume
of non-alkaline, diluted water-based soap solution.
Use the cotton cloth to gently rub the surface until it is completely dry.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
51 51