Initial Set-Up - TechniSat DIGITRADIO 370 CD IR Manual

6 Initial set-up

After switching on the DIGITRADIO 370/371 CD IR for the first time, the initial set-up
wizard launches.
Settings can all be changed at any time in the future.
> Use / to select the operating language and confirm with ENTER.
> To launch the initial set-up wizard, use / on the remote control to select
the [YES] field and press the ENTER button.
> In the next step you can select the time format. Select the desired setting [12]
or [24] and press the ENTER button to move on to the next step.
> Here you can select which source (DAB+, FM or the Internet) the DIGITRADIO
370/371 CD IR uses to obtain and update the time and date.
If you have selected Update from the NET, you must then select the time
zone so that the time is displayed correctly. Proceed to specify whether
summertime or wintertime is applicable at the time of setting.
> In the next step you can specify whether the DIGITRADIO 370/371 CD IR
should remain connected to the Internet when on standby. This can, for
example, be useful for App control. Power consumption is, however, increased
by using the standby mode.
> The network wizard then starts and you can set up an Internet connection.
Use the / and ENTER buttons to select the WiFi network you recognise
and enter the relevant password using the displayed keyboard (skip WPS).
Then select
correct a connection to the network is now established. The signal bar
in the status bar of the display indicates whether the connection has been
established. To cancel the entry, select
you make a typing error you can delete the last letter entered using
When the virtual keyboard is displayed, you can use / on the remote
control for navigation. The / buttons move the highlight upwards and
downwards, the / buttons move the highlight to the right and left.
> After completing the network set-up, confirm the message that the initial set-
up has been completed by pressing the ENTER button.
62
and press the ENTER button. If the password entered is
and press the ENTER button. If
.