Intended Use - SaMASZ XT 390 Operator's Manual

3. INTENDED USE

A mower XT is equipped with the „Perfect Cut" cutterbar. In Tab. 1 the mowing height differences,
depending on the tilt angle of the cutterbar are shown.
Tab. 1. Mowing height depending on the kind of the cutterbar and its tilt angle
„Perfect Cut" cutting bar
No tilt
Standard mowing height
Optional heights when using high mowing topping
Optional heights when using high mowing double topping
NOTICE:
It is recommended to mow very rare grass with zero angle inclination.
The rear mounted disc mower is intended to mow green fodder: grass, alfalfa, etc. on permanent
❑
grassland (pastures), crop fields without rocks, and to form loose rows of cut fodder. The pasture
or field being mown should be even, best if prepared by rolling. For the majority of tall grass the
first and second mowing should be done at height of 2.36"-2.75" (6-7cm), while for a majority of
short grasses at a height of 1.97" (5cm). The last mowing should be done a little higher - at 2.75"-
3.15" (7-8cm) from the ground.
WARNING!
It is forbidden to use the mower for purposes other than those listed in this
instruction. Using the mower for other purposes will be classified as use not
according with the intended use and could exclude the manufacturer from
responsibility from any resulting damages. The mower should be used, serviced
and repaired only by persons familiar with its characteristics and with safety
regulations. Unauthorized modification of the mower may release
the manufacturer from responsibility for any resulting malfunctions or
damages.
6
XT REAR DISC MOWER
3° tilt
OPERATOR'S MANUAL