Grandstream Networks HT801 Administration Manual page 46

Use Privacy Header
Use P-Preferred-Identity
Header
Use P-Access-Network-Info
Header
Use P-Emergency-Info
Header
SIP REGISTER Contact
Header Uses
Caller ID Fetch Order
Allow SIP Factory Reset
Determines if the "Privacy header" will be presented in the SIP INVITE
message and if it includes the caller info in this header. If set to Default, it
will add Privacy header unless special feature is Telkom SA or CBCOM.
Default is Default.
Specifies if the P-Preferred-Identity Header will be presented in the SIP
INVITE message. If set to "default", the P-Preferred-Identity Header will be
omitted in SIP INVITE message when Telkom SA or CBCO is active. If set
to "Yes", the P-Preferred-Identity Header will always be presented. If set to
"No", it will be omitted.
Default setting is: Default.
With this feature enabled, device will populate the WAN access node with
IEE-802.11a, IEE-802.11b in P-Access-Network-Info SIP header.
This feature support of IEEE-48-addr and IEEE-EUI-64 in SIP header for
emergency calls.
Specifies which address (LAN or WAN address) the device will detect to use
it in SIP Register Contact Header. When set to LAN, Contact header will
include local IP from ATA in REGISTER messages, while if set to WAN,
host/port/contact will be updated from SIP 401/403/404/407 Via header
"received"/"rport" parameters in REGISTER messages. Default is LAN
Address.
Selects the Caller ID display order which need to be respected by the
HT801/HT802. The available options are:
● Auto: When set to "Auto", the HT801/HT802 will look for the caller ID
in the order of P-Asserted Identity Header, Remote-Party-ID Header
and From Header in the incoming SIP INVITE.
Disabled: When set to "Disabled", all incoming calls are displayed
●
with "Unavailable".
● From Header: When set to "From Header", the HT801/HT802 will use
the FROM header to display the caller ID.
Allows to reset the devices directly through SIP Notify. If "Allow SIP Factory
Reset" is set to "YES" under FXS PORT, then the ATA receives the NOTIFY
from the SIP server with Event: reset, the HT should perform a factory reset
after the authentication.
The authentication in this case can be either with:
HT801/HT802 Administration Guide
Version 1.0.13.7
P a g e | 45