03
"Subnet "+ IP address
04
"Gateway "+ IP address
05
"DNS Server "+ IP
address
07
Preferred Vocoder
10
"MAC Address"
13
Firmware Server IP
Address
14
Configuration Server IP
Address
15
Upgrade Protocol
16
Firmware Version
17
Firmware Upgrade
47
"Direct IP Calling"
86
Voice Mail
99
"RESET"
"Invalid Entry"
"Device not registered"
Five success tips when using the voice prompt
Same as menu 02
Same as menu 02
Same as menu 02
Press "9" to move to the next selection in the list:
•
PCM U / PCM A
•
iLBC
•
G-726
•
G-723
•
G-729
•
OPUS
•
G722
Announces the Mac address of the unit.
Announces current Firmware Server IP address.
Enter 12-digit new IP address.
Announces current Config Server Path IP address.
Enter 12-digit new IP address.
Upgrade protocol for firmware and configuration
update. Press "9" to toggle between TFTP / HTTP /
HTTPS / FTP / FTPS. Default is HTTPS.
Announces Firmware version information.
Firmware upgrade mode. Press "9" to toggle among
the following three options:
•
always check
•
check when pre/suffix changes
•
never upgrade
Enter the target IP address to make a direct IP call,
after dial tone. (See "Make a Direct IP Call".)
Access to your voice mails messages.
Press "9" to reboot the device
Enter MAC address to restore factory default setting
(See Restore Factory Default Setting section)
Automatically returns to main menu
This prompt will be played immediately after off hook
If the device is not registered and the option "Outgoing
Call without Registration" is in NO
HT801/HT802 Administration Guide
Version 1.0.13.7
P a g e
|
21