Adding The Probe; Starting The Logger - LogTag Recorders UTREL-16 Product User Manual

Operating the Logger

Adding the Probe

Before the UTREL-16 can record temperature data you will need
to connect an external probe.
The UTREL-16 accepts any ST10 probe. Plug the sensor into the
socket located on the side of the device, as shown.

Starting the Logger

Before you carry out the following start procedure, please ensure you have plugged
the external probe firmly into the socket on the side of the logger.
Push button start
Press and hold the
symbol
S T ART I NG
option works very similar to other LogTag
Push Button Start with Start Delay
If the logger was configured for push button start with a start delay, the word
shown instead of the
The delay time is shown in hours and minutes, if it is less than 24:00 hours, and the word
is shown.
HOURS
The time counts down and the UTREL-16 starts recording when it reaches 0:00.
If the start delay is greater than 24 hours the word
of full days remaining.
Each time a user presses the
delay value is reset to its originally configured value.
UTREL-16 User Guide
button until
START
/Mark
is shown. The UTREL-16 now records temperature data. This start
symbol, once you have started the logger.
START
/Mark
disappears and the
READY
®
LED products.
is shown along with the number
DAYS
button during the start delay phase, the start
22
DELAY