LogTag Recorders UTREL-16 Product User Manual page 35

Operating the Logger
The logger has stopped, and no alarms were recorded
during the trip.
Here, the logger has stopped, and an upper alarm was
recorded during the trip.
Resetting the Logger
You can reset a UTREL-16 back to its original
started again.
When performing this procedure all recordings and statistics stored in the logger
are irrevocably deleted and cannot be recovered. Please ensure your data has been
saved!
All settings in the logger are retained.
For this process to work, the logger must be
.
STOPPED
Press and hold the
symbol will turn on.
When the
STOPPED
button within 2 seconds. The logger is now ready to
be started again.
If the button is released while
disappears, the display shows again, and the logger remains stopped. This means, the
data from the previous trip is still accessible.
The ability to reset a logger is enabled or disabled in the
configuring the UTREL-16 via LogTag
UTREL-16 User Guide
button. The
START
/Mark
symbol turns off, release the
STOPPED
®
state. Once reset, recording can be
READY
READY
is still on, or you wait until the
Advanced Settings
Analyzer.
symbol
READY
tab when
35