Table of Contents
Advertisement
Configuring the UTREL-16 for logging
This is done using LogTag
analyzing data.
Preparing the logger
Start the LogTag
l
Remove the protective cap from the UTREL-16's USB connector, plug it into a USB
l
socket on your computer and wait for the drivers to be installed
You will receive a message that a new USB device has been found, and a generic driver
will be installed
Once the driver is installed and the UTREL-16 is ready, it can receive configuration
data. Click LogTag - Configure; LogTag
display the configuration options for connected UTREL-16 units. Although you can
configure many devices at the same time
devices to about 10, using a powered USB hub. It is not possible to configure different
models at the same time.
Click Configure from the LogTag menu; LogTag
l
configuration options for connected loggers.
Standard Configuration Options
The standard configuration options include settings such as
start
recording,
logging interval
For detailed information about each parameter please read the section about Configuring a
®
LogTag
for logging in LogTag
4
You can configure more than one UTREL-16 at the same time, however it is practical to limit the number of units to about 6,
using a powered USB hub.
5
Depending on the factory configuration additional drivers may be installed at this time.
6
You can configure more than one UTREL-16 at the same time, however it is practical to limit the number of units to about 6,
using a powered USB hub.
UTREL-16 User Guide
®
Analyzer software, which can also be used for downloading and
®
Analyzer software.
5
.
and duration,
®
Analyzer's User Guide or press F1 for help.
®
Analyzer will scan all USB ports and
6
, it is practical to limit the number of
®
Analyzer will display the
User
start
delay, and password.
4
.
ID,
start
method,
pre-
13
Advertisement
Table of Contents
Need help?
Do you have a question about the UTREL-16 and is the answer not in the manual?