Getting Started - LogTag Recorders UTREL-16 Product User Manual

Getting Started

Getting Started
®
Your LogTag data logger is typically configured, placed
with goods that require monitoring and then
downloaded once the goods reach their intended
destination. Other applications may involve stationary
loggers placed in warehouses or to monitor fridges.
Each application requires several steps so you can
deploy your data logger and retrieve the recorded
measurements. You may be able to skip some of the
steps, depending on the way the logger was prepared
when it was delivered to you and how you wish to
analyze the data.
Things to do before you start logging
1. Download and install the latest version of LogTag
You can do this from the
2. Configure the unit using LogTag
3. Connect a probe
4. Start the logger.
Things to do while recording data
5. Clear an active alarm.
6. Review Minimum and Maximum values during the trip, as well as alarm threshold
violations.
7. Reset Minimum and Maximum values.
8. Place a mark in the recorded readings.
9. Stop the logger recording data.
Things to do when you have finished
10. Plug the unit into a USB port.
11. View the PDF report
12. Download the unit to LogTag
13. Re-configure or
UTREL-16 User Guide
LogTag Recorders Software Download
®
Analyzer.
and place the unit in the monitoring location.
generated by the UTREL-16.
®
Analyzer for analysis.
reset the logger, ready for a new trip.
®
Figure 1: LogTag recording cycle
®
Analyzer 3.
page.
11