Malfunctions - Wittenstein cyber dynamic system Operating Manual

Operating manual

9 Malfunctions

Fault
Drive system does
not start
Increased
operating
temperature
Increased
operating noises
Sporadic failure
The contact information of our Customer Service department can be found at the beginning
of this manual (inside cover page). Always state the serial number (SN) when doing so.
en-40
Changed operational behavior can be an indication of existing
damage to the drive system or can cause damage to the
drive system.

Do not put the drive system back into operation until the cause of the
malfunction has been rectified.
Possible cause
Connected incorrectly
Contact pin of the plug is bent
Parameter set does not
correspond to the drive
system
Drive system is heavily soiled
Ambient temperature too high
/ air pressure too low due to
altitude
Drive system becomes
very hot
Threaded spindle heavily
worn
Damaged bearings
Threaded spindle or gearbox
damage
Cable break
Doc. no.: 5022-D056658
cyber
Remedy
Check the connection using the list
of signals.
Check the connections.
Check the motor data record in the
power electronics.
Clean the outside of the
drive system.
Ensure adequate cooling.
Consult our Customer Service
department.
Consult our Customer Service
department.
Consult our Customer Service
department.
Consult our Customer Service
department.
Table 15: Malfunctions
®
dynamic system
Revision: 01