General Safety Instructions - Wittenstein cyber dynamic system Operating Manual

Table of Contents

Advertisement

®
cyber
dynamic system

2.13 General safety instructions

 Electrical connection work refers to all work on the electrical circuit for which faults and
associated hazards cannot be excluded.
Revision: 01
Faulty electrical connections or unapproved
live components can lead to explosions that can cause serious
injuries and even death.
Have all electrical connection work performed by trained technicians
only. The valid standards and directives must be observed for this.
Only suitable tools may be used for connection work.
Immediately replace damaged cables or plugs.
When the motor shaft is still turning or when the motor is externally
driven (generator operation), voltage is induced. This can cause
lethal current surges.
Ensure that no plugs or connections are exposed.
Connecting the power and signal supply lines under voltage is not
permitted and can lead to machine damage, serious injury or even
death.
Make sure that the power supply unit is always in a voltage-free
state before connecting.
Separation of the power and signal supply lines under voltage
is not permitted and can lead to machine damage, serious injury
or even death.
Make sure that the drive is always in a voltage-free state before
disconnecting its power and signal supply.
Doc. no.: 5022-D056658
Operating manual
en-9

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the cyber dynamic system and is the answer not in the manual?

Questions and answers

Related Products for Wittenstein cyber dynamic system

Table of Contents