Components Attached To The Output Side - Wittenstein cyber dynamic system Operating Manual

Operating manual

5.4 Components attached to the output side

For additional information, please contact our Sales department. Always state the
serial number (SN) when doing so.
en-22
Fastening screws that are screwed in too far can damage the drive
system.

Screw in the screws only up to their maximum depth.
 See dimensional drawing (5007–...).
Distortions during mounting operations can damage the drive
system.

Do not use force when mounting gearwheels and toothed belt
pulleys onto the output shaft.

Never attempt to assemble by force or hammering!

Only use suitable tools and devices for assembly.
Doc. no.: 5022-D056658
®
cyber dynamic system
Revision: 01