Change User 1/User 2 Memory During Pc Connection; Error Messages/Malfunctions - Microlife BP 3BU1-4 Instruction Manual

Wrist watch blood pressure monitor

Available languages

During the connection, the device is completly controlled by the computer.

Please refer to the 'help' file for software instructions.

6.2. Change user 1/user 2 memory during PC connection

While the monitor is connected with PC you can switch

between user 1 / user 2 memory data by pressing

«Time» key. Please note that new patient files needs to

be prepared on the PC for each user.

If an error occurs during a measurement, a long beep followed by 2 short

beeps will sound. Then the corresponding error code is displayed.

Error No.

Possible cause(s)

ERR 1

No pulse has been detected.

ERR 2

Unnatural pressure impulses influence the measurement result.

Reason: The arm was moved during theMeasurement (Artefact).

ERR 3

The inflation of the cuff takes too long. The cuff is not correctly

seated.

ERR 5

It occurs while the difference between systolic pressure and

diastolic pressure is too far away from acceptable and

reasonable range.

ERR 6

Due to unstable conditions during measurements, it is not

possible to calculate an average result.

The pressure in the cuff is too high (over 300 mmHg) OR the

pulse is too high (over 200 beats per minute). Relax for 5

minutes and repeat the measurement.*

The pulse is too low (less than 40 beats per minute). Repeat the

measurement.*

* Please consult your doctor, if this or any other problem occurs repeatedly.

Table of Contents