Discontinuing A Measurement; Memory Handling And User Setting; Viewing Measurements Saved In Memory - Microlife BP 3AX1 Instruction Manual

If the data of each cycle differ too much from each
other, a fourth measurement is performed before
the result is displayed. In rare cases when the
blood pressure is so unstable that even after four
measurements the data vary too much, an error
message is displayed. Refer to Error Messages and
Malfunctions (Section 7) at the end of this manual.

5.6. Discontinuing a measurement

If it is necessary to interrupt a measurement for any reason, for example if the patient feels unwell,
press the O/I button. The device immediately lowers the cuff-pressure and enters into sleep mode.
6.

Memory handling and user setting

6.1 Viewing Measurements Saved in Memory

The blood pressure monitor automatically stores each of the
last 30 measurement values. To view the stored measurements
for a user, press ▲ or ▼ in sleep mode. The last measurement
taken for the user is displayed.
The user, measurement sequence number, date, and time
are displayed on the top. Data obtained in Average Mode are
indicated by «MAM» in the upper right corner.
Press ▲ or ▼ to scroll through the list items. The first item in
the list is the average of all stored data.
Press OK and the display shows table of all data.
The first entry is the average. Data obtained in Average Mode
are indicated by an «A» at the very right.
Press ▲ or ▼ to scroll through the list.
13
Countdown
timer
Measurement
number
Measurement
number
3/03
sys
dia
pul
3/03
No.
avg.
1
2
3
4
15
9 MAM
15:48
124
mmHg
73
mmhg
77
/min.
15:48
sys dia pul
149 110 85
145 109 83
119 71 74 A
124 73 79
130 80 77 A