Integrated Peripherals - Boser HS-6036 User Manual

4.5 Integrated Peripherals

The IDE hard drive controllers can support up to two separate hard
drives. These drives have a master/slave relationship which is
determined by the cabling configuration used to attach them to the
controller. Your system supports two IDE controllers--a primary and
a secondary--so you can install up to four separate hard disks.
PIO means Programmed Input /Output. Rather than having the
BIOS issue a series of commands to affect the transfer to or from
the disk drive, PIO allows the BIOS to tell the controller what it wants
and then let the controller and the CPU perform the complete task
by them. This is much simpler and more efficient (also faster).
CMOS Setup Utility－Copyright ©1984-2001 Award Software
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
USB Keyboard Support
Init Display First
IDE HDD Block Mode
KBC input clock
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
UART2 Duplex Mode
RxD, TxD Active
IR Transmission delay
Onboard Parallel Port
Parallel Port Mode
ECP Mode Use DMA
EPP Mode Select
：Move Enter：Select
F5：Previous Values F6：Fail-Safe Defaults F7：Optimized Defaults
Integrated Peripherals
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
[Enabled]
[Enabled]
[PCI Slot]
[Enabled]
[8 MHz]
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[Normal]
[Half]
[Hi,Lo]
[Enabled]
[378/IRQ7]
[SPP]
[3]
[EPP1.7]
+ / - /PU/PD：Value F10：Save ESC：Quit F1：General Help
Item Help
Menu Level
37