Wireless Remote Control; Electrical Installation - Will Burt Night Scan Chief Series Operating Instructions Manual

NIGHT SCAN CHIEF
OPERATING INSTRUCTIONS
Figure 5-6 PMRC Panel Cutout Dimensions
A loose wiring connector is shipped with the PMRC to allow cable routing in the vehicle. Once the
cable is routed, wire the connector and attach the connector to the back of the PMRC.
To wire the PMRC connector:
1. See the Wiring Diagrams provided in the "Appendix".
2. Ensure power is properly disconnected from the system.
3. Connect the wires from the Control Cable to the supplied PMRC plug according to the wiring
diagram.
4. Plug the cable into the back of the PMRC.
5.5.3

Wireless Remote Control

Refer to TP-5543301 for installation instructions for the Wireless Remote Control option.
5.6

Electrical Installation

Refer to wiring diagram WD-46276 for electrical connections. The wiring diagram is located in the
"Appendix"section and is available at www.willburt.com. Be sure to follow the torque require-
TP-4602001-T PAGE 27 OF 80
DECEMBER 2020