Will Burt Night Scan Chief Series Operating Instructions Manual page 69

Message
WRN,2.04 Single-tilt - Tilt Stuck
Dual-tilt - Left Tilt Stuck
WRN 2.05 Right Tilt Stuck
WRN 2,06 Pan Stuck
2,01 Pan Limit Overlap
2,03 Posi- TILT pot stuck
tioner Only
2,04 Posi- PAN pot stuck
tioner Only
TP-4602001-T
DECEMBER 2020
Table 9-2 Error and Warning Codes for RCP
Meaning
Checked only when
moving out of a limit
position. The software
indicates the state of the
(left) tilt photo sensor
has not changed even
though the motor has
been told to move for
more than 1/2 second
Checked only when
moving out of a limit
position.
The software indicates
the state of the right tilt
photo sensor has not
changed even though
the motor has been told
to move for more than 1/
2 second
Checked only when
moving out of a limit
position.
The software indicates
the state of the pan
photo sensor has not
changed even though
the motor has been told
to move for more than 1/
2 second
The software indicates
both pan photo sensors
are blocked simultane-
ously
No movement detected
in expected direction for
2.0 seconds
OPERATING INSTRUCTIONS
Root Issue
Something is preventing
movement of left tilt
mechanism, the motor is
defective, or the RCP
board is defective
Something is preventing
movement of right tilt
mechanism, the motor is
defective, or the RCP
board is defective
Something is preventing
movement of pan mech-
anism, the motor is
defective, or the RCP
board is defective
Foreign material in one
of the photos sensors or
faulty photo sensor
Soft stops are not set,
something is preventing
the sense voltage (pot)
movement, the motor is
defective, the sense
voltage is going the
wrong way (miswire), or
the P/T drive board is
defective
NIGHT SCAN CHIEF
Potential Cause
PAGE 67 OF 80