Will Burt Night Scan Chief Series Operating Instructions Manual page 17

NIGHT SCAN CHIEF
OPERATING INSTRUCTIONS
Magnetic Down Switch: The magnetic down switch is activated by a magnet in the mast top
tube section. The position is factory set to indicate when the mast is fully retracted. Once acti-
vated, the mast is free to tilt back to the stowed position. See Section 7.5.4 for optional adjust-
ment.
Lights Mast Base Magnetic Down Switch
Optional
Camera or
Strobe
Location
RCP: Remote Control Positioner
Figure 3-2 Night Scan Chief Top View
Base Board: The PC Board (PCB) contains the system logical controller and provides landing
points for customer power supply and vehicle interlock cables. The PCB also distributes DC (and
optional AC light) power to components in the system.
Wiring Access Holes: Holes are provided in the bottom of the base to route power and data
cables into the mast system. The holes are protected by rubber grommets installed in the sheet
metal cutouts.
Look-Up Light: The Look-Up Light illuminates the operating space of the mast during any mast
motion to allow the operator to identify and avoid contacting unwanted obstructions during opera-
tion.
Saddle: The saddle supports the RCP and lights when nested for stable vehicle transit. The sad-
dle position will vary by model.
Lights: The Night Scan Chief systems can come with a variety of LED or Halogen lighting pack-
ages. Go to www.willburt.com for additional information on available light packages.
Camera/Strobe: Go to www.willburt.com for the latest optional cameras and strobe lights.
TP-4602001-T PAGE 15 OF 80
DECEMBER 2020