Will Burt Night Scan Chief Series Operating Instructions Manual page 27

1. Drill clearance holes for 1/4-20 screws located per Figure 5-4. Either two hole pattern can be
selected according to the space available.
2. Using the screws, washers, and nuts provided, attach the bulkhead to the vehicle. Torque the
1/4-20 screws to 62-70 inch-pounds (7-8 Newton-Meters). Alternative M6 stainless steel
hardware (not provided) can be used.
3. Attach the ground wire to the vehicle.
4. Attach the HHRC connector to the bulkhead connector by rotating the lug until it locks in
place.
Figure 5-4 HHRC Bulkhead Bracket Installation Dimensions
The HHRC comes with a holder (see Figure 5-5) to hang the HHRC. Attach the HHRC holder at
a convenient location to hang the HHRC in a dry, protected environment. To install the holder:
1. Drill two holes 1.125 inches (28.6 mm) apart as appropriate for the screws and mounting
method (nut/bolt or sheet metal screw or other) selected.
2. The mounting screws are provided by the installer based on the method of attaching
selected. The recommended screw size is M4 flat head to sit flush with the surface after
TP-4602001-T
DECEMBER 2020
NIGHT SCAN CHIEF
OPERATING INSTRUCTIONS
PAGE 25 OF 80