Will Burt Night Scan Chief Series Operating Instructions Manual page 70

NIGHT SCAN CHIEF
OPERATING INSTRUCTIONS
Table 9-2 Error and Warning Codes for RCP (Continued)
Message
2,07 Communication Timeout
2,08 Microprocessor error
2,09 RCP (Left) Tilt Up wrap
Only around
2,10 RCP (Left) Tilt Down wrap
Only around
2,09 Posi- Pan Pot Failure
tioner Only
2,10 Posi- Tilt Pot Failure
tioner Only
2,11 Right Tilt Up wrap
around
2,12 Right Tilt Down wrap
around
2,13 Pan Right wrap around
2,14 Pan Left wrap around
2,15 Left Tilt Limit Overlap
2,16 Right Tilt Limit Overlap
PAGE 68 OF 80
Meaning
The RCP or P-T Drive
board has not sent out
communications
recently
The RCP board has sent
an invalid message
The software indicates
the same photo sensor
was made before the
opposite limit photo sen-
sor was made to stop
rotation. This indicates
wrap around
The Positioner software
indicates the pot feed-
back voltage is out of
acceptable operating
range
The software indicates
the same photosensor
was made before the
opposite limit photosen-
sor was made to stop
rotation. This indicates
wrap around
The software indicates
the same photo sensor
was made before the
opposite limit photo sen-
sor was made to stop
rotation. This indicates
wrap around
The software indicates
both tilt photo sensors
appear to be blocked
simultaneously
Root Issue
Bad board or connection
in communications link
Indicates a software
problem
1. The flag that inter-
rupts the light may need
to be adjusted to go
deeper into the photo
sensor
2. The limit photo sensor
is defective
Defective pot, incorrect
wiring, bad connection,
defective P-T board
1. The flag that inter-
rupts the light may need
to be adjusted to go
deeper into the photo-
cell.
2. The limit photo sensor
is defective
The limit photo sensor is
defective
Foreign material in one
of the photo sensors or
faulty photo sensor
Potential Cause
TP-4602001-T
DECEMBER 2020