Will Burt Night Scan Chief Series Operating Instructions Manual page 72

NIGHT SCAN CHIEF
OPERATING INSTRUCTIONS
Table 9-3 Error and Warning Codes for HHRC (Continued)
Message
3,09 RF module Error
Table 9-4 Error and Warning Codes for Wireless HHRC
Message
8,07 Unrecoverable commu-
nication error
8,08 Internal firmware
detected error
8,09 RF module error
8,10 Memory Error
8,11 HHRC power up negoti-
ation failed
8,12 In-system reprogram-
ming failed
PAGE 70 OF 80
Meaning
Wireless Transmitter/
Receiver did not prop-
erly initialize
Meaning
No successful poll /
response communica-
tion for 250ms
Internal state machine
logic has detected an
invalid state transition
Wireless plug-in module
did not properly initialize
Memory Error
Unit could not establish
communication with any
HHRC (wired or wire-
less) when the NS 3.0 /
4.5 was powered up.
Panel Mount = unit 3,
Wireless HHRC = unit 6,
J-Box = unit 8.
System can have a
panel mount remote and
an HHRC, or 2 HHRCs,
but never 3 remote units.
Negotiation happens
every time the Base unit
is powered up
Dip-switch activated in-
system reprogramming
of attached devices was
not able to successfully
complete
Root Issue
Return HHRC to factory
for repair
Root Issue
Wireless Control Box is
not 'talking' to any other
board. Check Base
Board flashes and
HHRC display for x,07
Firmware logic error
Bad module
Wireless HHRC is not
plugged in during power-
up
Potential Cause
Potential Cause
TP-4602001-T
DECEMBER 2020