Settings - RESEARCH CONCEPTS RC4000 User Manual

RC4000 ACU Boardset

3.2.2.8 Settings

Note: The SETTINGS mode may not be available on all software versions.
The SETTINGS mode provides a way to change the operational characteristics of the RC4000 without
requiring to go to the configuration group of screens. It also provides a way to reset a drive error without
going to the DRIVE RESET maintenance screen.
1-LOCATE SOURCE:
<1>CHANGE SETTING
<0>RESET DRIVE
This selection is only available if an azimuth, elevation or polarization drive error (jam or runaway) is
active. Selecting 0 will attempt to clear the error.
1-LOCATE SOURCE:
SOURCE <0-NONE 1-RF 2-BCN 3-RCV2 4-DVB>
Selection 2 allows the user to change the signal source that will be used with the LOCATE function.
Chapter 3
RF SETTINGS
<0>RESET DRIVE
<MODE>MENU
85
Software