Table of Contents
Advertisement
RC4000 ACU Boardset
3.3.1.3 Super-User Access Items
This set of configuration groups allows the user to modify parameters that are not typically changed for a
particular installation. Usually these items address parameters that have been previously characterized
for a particular mount. The need to access these items would typically only occur if a unique
customization of the system was required.
3.3.1.3.1 Reset Defaults
RESET CODE:
<5 DIGIT CODE>RESET TO FACTORY DEFAULTS
The CONFIG-DEFAULTS screen is used to reset the controller's memory. Access to this item is allowed
only when the Expert Access level is set to SUPER-USER. To reset the system memory, the user must
key in a 5 digit code followed by the ENTER key.
There are two levels of resets that are possible. A first level reset clears NVRAM values including the
current selected satellite, the saved position, stored satellite data, and track table data. A full reset clears
the NVRAM data and resets all FLASH configuration values to default values.
NOTE: The first level access code is "12345". The full reset code is the same as the INSTALL level
Expert Access code given in Appendix A. This appendix may have been removed by a system manager
to limit use of the codes.
Chapter 3
0
CONFIG-DEFAULTS
112
Software
Advertisement
Table of Contents
