Table of Contents
Advertisement
4.2 Power up the projector
CAUTION: Sources should always be connected before the projector is powered up
CAUTION: Ensure that the main power cord complies with the national regulations where the
equipment is used.
Do not use unauthorized replacements.
Do not use power cords which are damaged.
Power up the projector using the keypad or remote
1.
Connect the line cord to the projector.
2.
Plug the 3–pronged cord into a grounded AC outlet.
The projector will begin warming up, and the backlight of the Standby /power button are flashing white.
3.
When the backlight on the standby button are constant white, the projector are in standby mode, ready to
be switched on.
4.
Press the standby button on the keypad or the power button on the remote to bring the projector up to on
mode.
The power button backlight on the keypad will flash blue while the projector is warming up.
5.
When the power button backlight is steady blue, the projector is ready for use.
Getting the projector started
R5911705 /02
Bragi
61
Advertisement
Table of Contents
