Barco Bragi Installation Manual page 40

Physical installation
Item
1
2
3
WARNING: A minimum of 4 anchor points must be used to secure the projector properly. It is
strongly recommended to use fixation points with as long mutually spacing as possible, in order to
increase the mechanical stability of the installation.
WARNING: Max tensile load for each anchor point is 43,75 kg. This must be a major consideration
when designing the brackets for fixation of the projector.
Anchor points front
There is also 12 anchor points in the front. They will be visible when the plastic front cover is removed. See
"Removal of the front cover", page 41 below, regarding how to remove the front cover.
These anchor points are mainly intended for lens support and other "extras", but can also be used as
anchorpoints.
WARNING:
When installing the projector in a motion platform application, the anchor points in front (Item 3 in
the illustration and table) must NOT be used. Use the anchor points in the bottom plate for this
purpose.
40 R5911705 /02 Bragi
Thread Dimension
M8
M6
M6
Max Hole Depth
15mm Anchorpoint / Ceiling / Rig
10mm Anchorpoint / Ceiling / Rig
10mm Lens and Blend support
Application
Mount
Mount
(Can also be used a
anchorpoints)