Profiles Setup Parameters - Barco Bragi Installation Manual

9.2 Profiles setup parameters

Available profile settings
Area of interest
Source
Image
PQ
Realcolor
Installation
Warp settings
Blend
Black Level
Settings
Currently selected source
• Brightness
• Contrast
• Gamma (Value and type)
• Intensity
• Saturation
• Sharpness
• Output resolution (e.g. 4K UHD, 4K UHD S or WQXGA on a WQXGA
UDX)
• Digital Zoom (Enabled status and factor)
• Digital Shift (Enabled Status, X and Y)
• Screen luminance
• HDR boost value
• Brilliant Color mode
• P7 desired values
• P7 measured values
• Lens parameters, if available (only valid if recalled with same lens)
- Iris
- Focus
- Zoom
• Lens shift (Vertical / Horizontal)
• Motorized Frame parameters, if connected
- Rotate
- Tilt
- Skew
• Shutter position
• Image orientation
• Scaling mode
Note: Only file-based warp supported via profiles
• Warp enabled status
• Selected warp file
• Transport delay
• Mask blend
- Enabled status
- Start and Width for each side
• File blend
- Enabled status
- Selected files
• S-curve ("gamma")
• Mask Black level
- Enabled status
- Width for each side
• File Black level
- Enabled status
- Selected file
GUI – Profiles
R5911705 /02 Bragi 157